Page 1 of 1

Monitor Problem

Posted: Mon Mar 19, 2007 1:38 am
by Steve R
In the last few days, my screen has been fluctuating in brightness. When it goes a little darker, there is also a bluish tint.

Is this a sign of the monitor itself dying, or is it an indicator of something wrong with the PC/motherboard?

The computer is a Packard Bell with a flat screen, about 3 1/2 years old.


Re: Monitor Problem

Posted: Mon Mar 19, 2007 2:04 am
by planeterotica
Have you checked your connections because this happens with my screen but i know it is a dodgy connection on the comp that i havnt got round to putting right yet.




Re: Monitor Problem

Posted: Mon Mar 19, 2007 3:33 am
by Steve R
Yes, I have checked that, thanks Graham.


Re: Monitor Problem

Posted: Mon Mar 19, 2007 7:58 am
by jasonhallceltic
is there anything electrical or magnetic in close proximity, like speakers anything like that, that sometimes cause the monitor to go funny, or a big power pack directly behind, other than that yeah sounds like its about to die!

Re: Monitor Problem

Posted: Mon Mar 19, 2007 8:03 am
by Jacques
Could always hit it with a hammer - standard engineering practice. If that doesn't fix it I'd say it is either going to die or your graphics card is going to die or you have a dodgy connection somewhere.

Re: Monitor Problem

Posted: Mon Mar 19, 2007 11:55 am
by welshfella
Had similiar problems with my laptop. The screen in permanatley dark now - if you shine a torch at it though, you make things out. Searched a few internet forums and either my backlight or the invertor (bascially a flourescent tube starter) has gone. Do you think I can find anywhere that sells backlights and starters!

Re: Monitor Problem

Posted: Mon Mar 19, 2007 12:14 pm
by Steve R
Actually, the darkening of the screen hasn't happened since I checked the connections, come to think of it.

Maybe that's all it was after all.


Re: Monitor Problem

Posted: Mon Mar 19, 2007 3:51 pm
by johnsix
Here are a few for you;




Good luck.

Re: Monitor Problem

Posted: Mon Mar 19, 2007 7:45 pm
by sparky
If it is a CRT monitor 1 gun can fail or be intermittant in the tube, or there can be intermittant connections to the tube or on the circuit boards.

If it is LCD and leads OK probably fault on circuit board.

With prices now not worth considering repair unless you have a mate who will look in exchange for a few pints / packets of fags / porn DVD or two.

Re: Monitor Problem

Posted: Tue Mar 20, 2007 1:47 am
by Steve R
Thanks again, Graham.

It's now 24 hours since I gave the connections a shove and it's still fine.