Page 1 of 2
technical help needed
Posted: Fri Feb 10, 2006 6:28 pm
by eroticartist
I have a computer offline that is used for editing. When I open Windows XP then a strange code appears instead of English?
Anyone know what this is and what to do?!confused!
Mike Freeman.
Re: technical help needed
Posted: Fri Feb 10, 2006 6:30 pm
by Jacques
What code comes up?
Re: technical help needed
Posted: Sat Feb 11, 2006 10:26 am
by eroticartist
Hi Jaques,
Lots odd geometric shapes and other symbols.!confused!
Mike
Re: technical help needed
Posted: Sat Feb 11, 2006 10:30 am
by eroticartist
I can get into Windows no problem but is all in this code! Start and all the programs are there.Do you think that I should still boot in safe mode? What is the next step?!confused!
Mike
Re: technical help needed
Posted: Sat Feb 11, 2006 10:45 am
by Jacques
Sound like it could be that either your graphics card has died or your graphics card driver is corrupt - had the same problem just before Christmas, I re-installed the driver and everything worked fine after that.
Re: technical help needed
Posted: Sat Feb 11, 2006 11:45 am
by eroticartist
Hi Jaques,
I tried to re-install the VGA driver but as everythingis in code I was not
successful. I think that you are right though!
Thanks.
Mike
Re: technical help needed
Posted: Sat Feb 11, 2006 12:45 pm
by Jacques
I had another thought - have you uninstalled any software recently? If you have, you may have uninstalled the font that windows uses for menus and such like. If so try a System Restore.
Re: technical help needed
Posted: Sun Feb 12, 2006 1:22 pm
by eroticartist
Hi Jaques,
I have not uninstalled any software.
When I uploaded the drivers a driver icon appeared on the desktop?
Regards,
Mike.
Re: technical help needed
Posted: Mon Feb 13, 2006 8:09 am
by Jacques
What graphics card are you using?
If it's ATI it maybe a shortcut to Catalyst Control Center.